1. Simple structure, Easy
to Maintain and Debug Control
2. Relying on
potentiometer adjust gyro sensitivity.
3. Full servo signal
output, support normal ESC / analog servo
4. Support for single-axle
/ UFO, Y3 3-axle, Y4-type 3-axle, 4 axle, 6 axle, V22 flight
5. Supports 4-axle "+" and
"X" flight mode, support for six-axle "HEXA6" and "Y6" flight
A 2212 A2212 1000KV Brushless
Outrunner Motor W/ Mount *4pcs
Max Efficiency: 80%
Max Efficiency Current: 4-10A
Current Capacity: 12A/60s
No Load Current @ 10V: 0.5A
No. Of Cells: 2-3 Li-Poly
Motor Dimensions: ?27.5 x 30mm
Shaft Diameter: ?3.17mm
set 2212 1000KV Brushless Outrunner Motor with Mounts *4
FMT 30A ESC Speed Controller *4 pcs
This ESC do not have the English instruction.
Before producing, the manufacturer have set up the program, the ESC do not need additional program.
JMT 30A Brushless ESC Speed Controller For RC RC Quadcopter Hexacopter Multi-Rotor Aircraft
2. 100% Brand New!
3. No manual.
4. For KK MK MWC RC Quadcopter Hexacopter Multi-Rotor Aircraft
1.1 Output: Continuous 25A, Burst 40A up to 10 Secs.
1.2 Input Voltage: 2-4 cells lithium battery or 5-12 cells NiCd/NIMh battery.
1.3 BEC: 3A
1.4 Max Speed: 210,000rpm for 2 Poles BLM, 70,000rpm for 6 poles BLM,
35,000rpm for 12 poles BLM. (BLM: BrushLess Motor)
1.5 Size: 45mm (L) * 25mm (W) * 11mm (H).
1.6 Weight: about 25g.
2.1 Safety Arming Feature: Regardless the throttle stick position, the
motor will not spin after battery connected.
2.2 Throttle Calibration: Throttle range can be configured to provide best
throttle linearity, fully compatible with all market available transmitters.
2.3 Programmable Items: Brake Setting: brake enabled / brake
disabled. Battery Type: Li-xx(Li-ion or LiPo) / Ni-xx(NiMh or NiCd). Low Voltage Protection Mode(Cutoff Mode): Gradually reduce the
output power / Cutoff the output power. Low Voltage Cutoff Protection
Threshold (Cutoff Threshold): low / medium / high. Start Mode:
normal / soft / very soft. Timing: low / medium / high. Reset:
reset all the programmable items to their default settings.
2.4 Full Protection Features: Low voltage cutoff protection / Over-heat
protection / Throttle signal lost protection.
3.1 Military standard capacitor of extreme low resistance increases the
ability of prevention of unwanted RF noise during flying.
3.2 Extreme low resistance PCB is helpful for getting a super current
3.3 Microprocessor uses separate voltage regulator IC, with good anti-
11.1V 20C 2200Mah Lipo Battery *1 pcs
battery features high efficient and high discharge,use a inspection machine to match packs, suitable for All Align trex 450
rc heli and other professional model
airplanes, cars, and guns.
Continuous Discharge: 10C, Burst Discharge: 15C. Normal operating temperature is
approx. 40-65°C(within 80% of rated
discharge). Max. temperature: 80°C.
high energy Li-poly Battery, please do not over-discharge, over-charge
batteries, or result over-high temperature. Discharging
capacity can't exceed 80% of the max capacity after full
charging to ensure a good cycle performance. Recommend to full
a brand new battery before using and only discharge the battery 50% for first 5
to make a good efficiency of the battery. Please make it a habit to always count
for flight, or please set a low voltage protection on ESC (Cell voltage after
stopping using can not lower than 3.2V). Do not use the
battery at insufficient of voltage.
Do not expose batteries to sunshine or store/ charge
batteries at the temperature up to 35°C in a airtight car.
The environment high temperature could cause the damage or the
of burst. If the battery becomes hot while high current discharging or
please do not charge the battery immediately. Wait to
cool down(about 20 mins), then inspect to recharge. If against follow the original
factory using rules, possibly cause the battery to inflate or
any dangerous accident happens.
Efficient/Hardness Blade Propeller TL2710-01/TL2710-03 (2 pairs)
(For the color of propeller,we will ship random color according to our invertory)
Digital 2.4GHz 6-Channel RC and receiver
system T6EHP adopted FHSS 2.4GHz technology, it is applied for 3D helicopter.
Owing to the most advanced 2.4GHz radio control technology, it is needless to
fit crystals for both transmitter and receiver, meanwhile RC system can avoid
the interaction problem best up to the advanced code matching
Model Select six model
Model Type helicopter programming. (for airplane is another
Servo Reversing on all six channels.
Dual Rate/Exponential for
ailerons, elevator and rudder.
End Point Adjustment fine-tunes servo throws
on all six channels.
Digital Trim stores trim settings for each model for
aileron, elevator, rudder and throttle.
Fail Safe a safety throttle setting
in case of loss of transmitter signal.
Battery Fail Safe moves the throttle
to a preset position when the airborne pack reaches 3.8V.
Stick Mode choose
from Mode 1 through 4.
Range Checking Power Down reduces transmitter output
power for up to one minute, allowing range checking from 50 paces away.
Changeable Throttle Stick select ratchet for airplanes or smooth for helis.
Adjustable Stick Length choose the length that suits your flying style.
5-Point Normal and Idle Up
Throttle Hold for autorotation.
Mixing) mixes rudder and pitch together.
Gyro Mixing two gyro gain settings
can be programmed and selected during flight.
Swash to Throttle Mixing
corrects slowing of the engine's speed caused by the swashplate.
Types choose from 1S (independent aileron, pitch and elevator servos linked to
the swashplate), 3S (120° CCPM), or 3E (90° CCPM).
Swash AFR Adjustable
Function Rate, for use with 1S, 3S or 3E swash
(Please pay attention this:
The Radio Controller Software upgraded,The wire connecting for Receiver and KKMulticopter board has been changed.Please check and like this:)